32 Diode Bridge Compressor

[Heikki]

Schematic

32.pdf

(276.77 KiB) Downloaded 227 times

Layout

layout.pdf

(3.08 MiB) Downloaded 208 times

Gerber Files here
viewtopic.php?t=104

[Heikki]

Testing the build

64proto1.jpg (2.97 MiB) Viewed 81271 times

[scott2000]

Some polymer caps ..

[scott2000]

Had some interested in a 1U version. Seems like it would be easy enough to mount the sidechain boards and just wire pots in? Could use those dact type stepped pots even and only have a single set of knobs for stereo since those are dual gang?

Stepped switches would be a lot to wire...

Talking about the first revision boards..Not sure how big the new ones are??

[Heikki]

This version has the everything on one board. There's no separate sidechain boards. Pots or rotary switches are wired from the board.

[scott2000]

I didn't realize that. The new diode version doesn't use the sidechain boards?
It wasn't clear in the build pic but it wasn't really a build I guess....

[Heikki]

In the picture the grey wires coming from underneath the board are wires to the potentiometers.

[OneRoomStudios]

Very cool design! What are the dimensions of the board? Also, how much current does it draw?

[Heikki]

Current draw at idle is maybe 60mA. Current draw will be more if the output is driving 600 ohm loads, but those are rare these days. I used a 18V/1A wall wart for power.

I'll check the dimensions when I get home.

[Heikki]

Dimensions are 270mm x 200 mm.